RT-Self Test Board-1 RT-Self Test Board-2 for RT809H programmer

€4.97
Tax excluded

RT-SelfTestBoard-1 RT-SelfTestBoard-2 for RT809H programmer

Chipsetpro.com

Chipsetpro.com

Quantity
Delivery will take 14-28 days

The use of programmer selftest command,to check if there is problem itself.

Selftest way I:

Step 1 : Input the SELFTEST in the Enter chip printing,click

Step 2 : Click ,look at the hint in the display area,selftest 0 means the test pass;

Step 3 : Install the NO.1 test board and the short port of VGA ISP(short circuit the 4pins and 11pins,12pins and 15pins);

Step 4 : Click ,check the hint in the software,it will hint Selftest 1,test pass;

Step 5 : Install the NO.2 Self Test Board;

Step 6 : Click ,check the hint in the software,it will hint Selftest 2, test pass;

Selftest way II :

Step 1 : When there is no chip on the locking seat,input the type of 25XX in Enter Chip Printing;

Step 2 : Click ,it will hint that there is no chip or the locking seat hasnt been impacted well,which is normal;

If it hints that there may be a pin empty solder;

Attention : In the case of that some users have no test board,as long as the selftest 0 and 25 chip test pass,the machine is normal.

If there is other hints when doing selftest 0,the way to deal with it could be as following:

The problem of connection with computer and the programmer,please step-by examine according to the hint of failure process;

Hardware trouble like pin electric leakage,problems inside the pins,VPP open circuit,GND open circuit,VPP short circuit,VCC short circuit,GND short circuit,VPP protection not shut off,which must be returned to factory to repair.

CH004408

No customer reviews for the moment.

Write your review

RT-Self Test Board-1 RT-Self Test Board-2 for RT809H programmer

RT-SelfTestBoard-1 RT-SelfTestBoard-2 for RT809H programmer

Write your review

16 other products in the same category